DAILY MAINTENANCE
DAILY MAINTENANCE
40
7.One side of the optical fiber is up or down and cannot be restored by cleaning the V slot and resetting --
open the mobile phone APP and connect it to the machine, then select the welding setting -- operation mode
-- factory core adjustment, and select manual adjustment when returning. If it is on the left, adjust it to the
center of the screen by pressing the up and down triangle button on the left, and vice versa.
If the left side is not
right, click on the
left side of the upper
d o w n a d j u s t m e n t ,
otherwise adjust the
right side
8.High welding loss or no connection--the loss of welding is determined by many reasons: the quality of the
machine, the current intensity of the machine, the flatness of the cutting surface, the cleanliness of the
optical fiber, whether the type of optical fiber matches, the quality of optical fiber and even whether the
optical fiber is tight will affect the welding effect. Then we need to pay attention to the following aspects:
Please first confirm whether the light loss caused by welding is too large, for example, make a single
point of welding with jumper wire to measure the loss,try another welding machine. Confirm the
welding problem, and then carry out the later debugging.
①
First, best to do a discharge calibration before use to ensure the effect if the use environment of the
machine be changed or placed for a long time.
②
Second,after stripping off the coating, the optical fiber needs to be wiped clean with alcohol cotton
before cutting. (alcohol should be 95% or more).
③
Third, check whether the left and right optical fibers are the same type. Single mode and multi-mode
fiber cannot be fused together, and there are many types of single mode and multi-mode, and the same
type of single mode or multi-mode fiber should be fused together as far as possible, so as to minimize the
loss.
④
Fourth, adjust the cutting knife to get better cutting effect and reduce the loss. (especially multi-mode
fiber, if the cutting surface is not good, it will lead to bubbles and bulges during welding, which is caused by
the bad cutting surface)
⑤
The fifth, welding can still be good, set on the heat shrinkable tube is not good, or put a few days is not
good. If it is cable docking is mainly heating slot time is not enough. In the case of leather-fiber docking or
leather-cable and tail-fiber docking, this will also happen without the use of double-wire heat-shrinkable
tubes and protective tubes, except for insufficient heating time. Extending the heating time by 3 to 5
seconds, as well as changing to double-wire heat-shrinkable tube and adding protective tube can be
solved.
