MULTI-TOUCH OPERATING PANEL
ETT 764
7 Assembly/Installation
7.1 Check Contents of Delivery
Ensure that the contents of the delivery are complete and intact. See chapter 1.3 Contents
of Delivery.
INFORMATION
On receipt and before initial use, check the device for damage. If the
device is damaged, contact our customer service and do not install the
device in your system.
Damaged components can disrupt or damage the system.
7.2 Installation
The device’s power loss can reach up to 16 watts. To ensure the necessary air circulation
for cooling, the mounting instructions must be followed!
7.3 Mounting Instructions
The following instructions must be followed when installing the terminal:
l
For installation with the screw terminals provided, it is recommended that the
installation panel have a material strength of 1 mm and maximum 3.5 mm. The
screw-in brackets can be tightened with a torque of 0.15-0.2 Nm. For this purpose,
a 3 x 0.5 flat-tip screw driver is required.
l
To avoid damage to the aluminum frame, it is important to ensure that during
installation, the contact surface is clean (free of debris, uneven areas). Unevenness
can lead to stress on the glass/aluminum frame or contamination from dust and
water.
To dissipate waste heat from the terminal, the clearance between the back of the terminal
and the back wall of the control cabinet should be at least 80 mm.
24.03.2021
Page 23
