BUILD-IN TOUCH TERMINAL
ETT 1034
19.02.2019
Page 45
To mount PIM with TP, follow the steps below:
1.
Ensure that an ESD-compliant working
method is followed (ESD armband,
ESD clothing).
2.
Disconnect the PIM as well as the TP
from voltage.
3.
Place the TP flat on its back.
4.
Place the PIM onto the TP so that the
locking clamps of the PIM are securely
held in the notches of the TP.
5.
Slide the PIM in the direction of the ar-
rows shown.
6.
When locking, a “click” can be clearly
heard and the short side of the PIM
closes evenly with the housing of the
TP.
7.
Secure the PIM to the TP using the
previously loosened screws and a
TX10 Torx screwdriver with a torque of
0.7.
16.2 Disassembly
To separate the two components, follow the steps in chapter 16.1 in reverse order.
