ETT 1034
BUILD-IN TOUCH TERMINAL
Page 34
19.02.2019
13 Maintenance
During maintenance as well as servicing, the safety instructions from chapter
2must be observed.
13.1 Maintenance
This product was constructed for low-maintenance operation.
13.1.1
Calibrating the Touch Screen
The touch screen is calibrated at the factory. You should therefore only recalibrate the touch
screen when press-point changes are noticed.
The calibration can be run either with the following CLI command or via the application (as
long as it is provided by the application engineer).
calib
13.2 Repair
When sent for repair, the panel should be transported in the original packag-
ing if possible. Otherwise, packaging should be selected that sufficiently pro-
tects the product from external mechanical influences. Such as cardboard
filled with air cushioning.
In the event of a defect/repair, send the panel with a detailed error description to the address
listed at the beginning of this document.
