ETT 1034
BUILD-IN TOUCH TERMINAL
Page 22
19.02.2019
6
Cooling
The power loss in the ETTs can reach up to 19 Watts. To ensure the necessary air circulation
for cooling, the following mounting instructions must be followed!
7
Mounting Instructions
During installation, caution must be taken to ensure that the aluminum front
is not damaged.
The following instructions must be followed when installing the terminal:
•
For installation with the screw terminals provided, it is recommended that the installation
panel have a material strength of at least 1 mm and a maximum of 2 mm. The screw-in
brackets can be tightened with a maximum torque of 0.2 Nm. For this purpose, a 3x 0.5
flat-tip screw driver is required.
•
To avoid damage to the aluminum frame, it is important to ensure that during installation,
the contact surface is clean (free of debris, uneven areas). Unevenness can lead to
stress on the glass/aluminum frame or contamination from dust and water.
To dissipate the power loss from the terminal, the clearance between the back of the terminal
and the back wall should be at least 100 mm.