Sigma ZIRC-SD3502, Руководство пользователя

Страница: 7 / 12

ZIRC-SD3502 Z-Wave AV / IR Remote Control
1 1
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2012 Sigma Designs, Inc.
REV 0x0017
STOP 0x0014
FWD 0x0016
REPEAT 0x0107
ANGLE 0x003C
PAUSE 0x0015
SLOW 0x011E
TIME_SEEK 0x017F
AUDIO 0x0041
SUBTITLE 0x0130
ZOOM 0x0169
RED 0x009D
GREEN 0x009B
YELLOW 0x009F
BLUE 0x009A
2.4 Low battery
When battery is low, any key press will be immediately followed by 3 red LED blinks. This is an
indication to replace batteries. This replaces the normal LED indications described in this document.
2.5 Subsequent Inclusion/Exclusion
Set the STB to add or remove the remote control as required. Press & hold SETUP+HOME for 5 seconds.
The LED should blink green once to signal it has entered learn mode, at which point the use may release
the buttons. The LED should blink 3 times green on success or red on failure.
2.6 Reset
Press & hold SETUP+RETURN for 10 seconds. The LED should blink green once on success. This will
restore ZIRC to factory default setting.
2.7 Enable Over-The-Air firmware upgrade
Press & hold SETUP+ENTER for 5 seconds. The LED will start to blink amber and the firmware upgrade
can start. If the firmware is transferred successfully the LED will blink GREEN 3 times. If the firmware
upgrade fails the LED will blink RED 3 times and a retry must be done.