Page 5
1.
State of the art CNC Machining and 1/4 turn ceramic disc cartridges mean
precision made product. NO HEAT, NO TORCH ... Shall be applied to the valve
assembly.
2.
Install adapters at each port, seal the joint, and then run the required
copper lengths to the in-coming water. Solder the copper connection a
minimum of 8”away from valve body.
3.
Use approved thread sealers at all joints. DO NOT USE PLUMBERS PUTTY, USE OF
ANY CAUSTIC MATERIAL MAY HARM THE FINISH AND OR INTERFERE WITH PROP
-
ER
FUNCTION OF THE CARTRIDGE.
4.
solder, sand, silt, and debris that have loosened up from the installation
that may come from any new additional installation such as a water heater.
5.
6.
All other Eurotherm Thermostatic valves that come equipped with
the Bi-Metallic strip cartridge
have built-in check valves to protect cross-connection.
7.
All valves that are not tooled with NPT connectors come with conversion
adapters. (Metric and NPT)
8.
dealer for installation assistance. When installing body sprays with 3/4” systems
no more than three sprays should be plumbed out of
the
9.
Remember water pressure comes from your local water supplier and can be
measured at the source on the street.
10.
Pressure or water velocity is not a function of the valve.
11.
The water meter that is supplied for your home should be 25% larger than the
valve.
12.
Do not attempt installation of the product if you do not understand these
instructions.
13.
INSTALLATION
CAUTIONS!
Revised 7-12-19
FORM SIG 063