page 16
Software Installation Rev NS001b004
Software Installation for Windows NT 4.0
To install NetStream 2000TV software under Windows NT 4.0:
1.
Start Windows, if your system does not boot directly into Windows.
2.
Insert REALmagic® NetStream 2000TV Windows NT Disk #1.
3.
Click Start on the task bar, and then click Run.
4.
Type
A:\SETUP
in the dialog box, then click
OK
(this example
assumes that your floppy disk drive letter is A:).
5.
Click Next on the
Welcome
screen when it appears.
6.
When prompted to choose the destination location, click
Next
to
accept the default or
Browse
to select a location of your choice.
7.
At the
Folder Selection
window, click
Next
to accept the default,
or enter a name of your choice. The files are copied.
8.
Insert REALmagic® NetStream 2000TV Windows NT Disk #2
when prompted. Then, click
OK
. After setup, the system will
display a message to run it again later to set a region code.
9.
Click
OK
to restart Windows, let the new settings take effect, and
return to the desktop.
10. To complete installation, you must run the
REALmagic®
Configuration Utility
, as described in the next section.
Border Adjustment and Color Calibration
Set Border Adjustment and Color Calibration once for each display
setting (resolution, number of colors, and refresh rate):
1.
After rebooting, start the
REALmagic® Configuration Utility
.
From the Start menu in the Taskbar, navigate to
Programs>REALmagic NetStream>REALmagic Configuration
to open the
REALmagic Configuration…
dialog (Figure 4).
Figure 4. REALmagic® Configuration
2.
Click
Auto Calibration
, and then click
OK
. As the software
automatically calibrates, screen colors may flicker.
Note 11.
If Windows NT Plug and Play support auto-detects the NetStream
2000TV card during startup and prompts you to install a driver, select the
option titled Do not install a driver (Windows will not prompt you again).
Then continue with the instructions below.