ICD-1500-Adapter-Boards
© SightLine Applications, Inc.
24
Connector J1:
Digital Video Port and Serial communications.
This connector is designed to mate with
the 1500-OEM J4 connector. See the ICD-1500-OEM for the correct pin-out description.
Connector J2:
26-pin SDR Camera Link connector.
This is a standard 26-pin Camera Link connector.
Camera Link uses differential signal pairs for both video and serial communication. These signals are
routed to an LVDS converter. The output is then routed to the J4 connector for use by 1500-OEM. The
signals below are provided for reference use only. See the Camera Link specification for details when
customizing a Camera Link adapter board.
Table 21: Connector J2 Pin-Out
Pin
Signal
Pin
Signal
1
Ground
14
Ground
2
NC
15
NC
3
NC
16
NC
4
NC
17
NC
5
NC
18
NC
6
C
19
CAMTXOUT-
7
CAMRXIN-
20
8
RXIN3+
21
RXIN3-
9
22
RXINCLK-
10
RXIN2+
23
RXIN2-
11
RXIN1+
24
RXIN1-
12
RXIN0+
25
RXIN0-
13
Ground
16
Ground
NC = Not Connected. Pins 27 and 28 (SHIELD) are not shown. On the board they are tied to common
ground.
Table 22: 1500-CL Test Points
Label
Signal
RX
SOMRXIN Serial port 2
TX
SOMTXOUT Serial port 2
Clock Divider
The 1500-OEM does not utilize the Data Valid (DV) signal to clock out video. There is an on-board clock
divider available (U1) for this purpose. If the clock from the camera is less than 20 MHz, R34 (FLIR)
should remain populated with a zero-ohm resistor, however if the clock from the camera is equal to or
greater than 20MHz, R34 should be removed and R33 populated with a zero-ohm resistor instead.
15
Questions and Additional Support
For questions and additional support, please contact
. Additional support documentation and
Engineering Application Notes (EANs) can be found on the Support pages of the SightLine Applications
