.
86.
Install the receiver and battery pack so that the model balances at the point shown on the plan. Wrap the battery and
receiver with foam rubber. If necessary, add weight to the nose or tail until the model balances at the point shown on the
plan with the fuel tank empty. Mount the switch in the left fuselage side. Run the receiver antenna through the rear
fuselage and out a small hole in the fuselage side just behind F-10 and below the stabilizer.
87.
Set the control throws to the measurements shown on the plan.
88.
Verify that the model balances at the point shown on the plan before flying. Verify that the control throws are set and that
the controls move in the proper direction.
89.
Always pre-flight your model thoroughly before each flight. It is your responsibility to verify that your model is airworthy.
Always follow established safety guidelines while starting and operating the engine, radio and while flying the model.
WARRANTY
Herr Engineering Corp. guarantees this kit to be free from defects in both materials and
workmanship at the time of purchase. This warranty does not cover any component damaged buy
use or modification. In no case shall Herr Engineering Corporation's liability exceed the original
cost of the purchased kit. Further Herr Engineering Corp. reserves the right to change or modify
this warranty without notice.
In that Herr Engineering Corporation has no control over the assembly or use, no liability shall be
assumed or accepted for any damage resulting from the use by the user during construction of the
kit or the use of the final user assembled product. By the act of building this kit and/or using the
final user assembled product, the user accepts all liability.
If the buyer and/or user is not prepared to accept all of the liability associated with this product, he
is advised to immediately return this kit in new and unused condition to the place of purchase for a
full refund.
© Copyright SIG Mfg. Co., Inc.
SIG MFG. CO., INC............Montezuma, Iowa 50171-0520
LIMIT OF LIABILITY:
In use of our products, Sig Mfg. Co.'s only obligation shall be to replace such quantity of the product proven to be defective.
User shall determine the suitability of the product for his or her intended use and shall assume all risk and liability in connection
therewith.