14
❑
15) Install the Cowl, Propeller, and Spinner
a)
Install the battery hatch and test fit the cowling , propeller, and
spinner on the fuselage. As you pass the cowl over the motor,
make sure all the wires are out of the way. Carefully adjust
the exact position of the cowling. Make sure you have
adequate clearance between the front of the cowl and the back
of the propeller, and that the prop shaft is centered in the hole.
(No part of the spinner or propeller should come into contact
with the cowl.) When you are satisfied with the cowl’s
placement, tape it in place using masking tape.
b)
Use a 1/16" bit to drill holes in the firewall for the cowl mounting
screws, through the pre-drilled holes in the cowl.
c)
Remove the cowl and thread a M3 x 10mm screw into each of
the four cowl mounting holes, then remove the screws.
d)
Apply a drop or two of thin CA to each of the four cowl mounting
screw holes. This will harden the wood, and help to keep the
screws from vibrating loose.
e)
The cowl can now be permanently mounted to the fuselage.
f)
Mount a suitable propeller (not furnished) and the included
spinner (optional) on your motor. Be sure to balance the
propeller before installation.
Содержание Edgetra ARF
Страница 1: ......
