Sig Marine Sig100, Руководство по эксплуатации и установке

Страница: 27 / 35

27
15. Burner Assembly
Your diesel heater has been equipped with a Airflow burner. There are two
components in the burner that must be correctly placed for the heater to
operate properly. The burner ring must be placed at the top of the pot so the
outside edge of the ring fits into the groove in the top of the pot. Ensure that
the ring fits in evenly and snugly all the way around the pot and that all of
the oval shaped slots are clearly visible.
The second component is the superheater. The superheater is placed through
the burner ring and will sit on the bottom of the burner with the round 2”
disc sitting 2” up from the bottom of the burner. The bottom of the
superheater should sit flat on the bottom of the burner to radiate heat to the
fuel coming in through the center of the superheater washer. This will need
to be kept clean to allow fuel to flow through it. The ring of the superheater
will sit up above the burner ring where the flames are and radiate heat down
to the vaporizing fuel. The 2” round disc sitting 2” above the bottom of the
burner deflects the hot rising vapor up the sides of the burner pulling in the
primary air needed to mix with the fuel.