Sierra Wireless AirLink Raven-E 1 series, Руководство пользователя

Страница: 106 / 120

Configuration Commands
Rev 3.0B Feb.08 95
+CTA= n
Inactivity timer, in seconds. Typical network settings cause a
link to go dormant after 10 to 20 seconds of inactivity, no
packets transmitted or received. This time can be shortened to
release the physical RF link sooner when the application only
transmits short bursts.
• n=0 : Allows the cellular network to determine the
inactivity timer.
• n= seconds (maximum 20 seconds)
$QCMIP= n
Mobile IP (MIP) Preferences. On a Mobile IP network, a device
connects to the network using PPP. During the negotiation
process the Raven ‐ E is NOT required to present a username
and password to authenticate because the authentication
parameters are stored in the modem itself.
• n=0 : Disabled, SIP only
• n=1 : MIP preferred
• n=2 : MIP only
Note: Your account with your cellular carrier may not support Mobile
IP.
~NAMLCK= nnnnnn
The NAMLCK is the modem ʹ s 6 ‐ digit OTSL (One Time
Subsidy Lock), MSL (Master Subsidy Lock), or SPC (Service
Provisioning Code). Your cellular carrier will provide the
unlock code.
• nnnnnn=6 digit unlock code
Caution: If the number is accepted by the modem, the OK result
code is returned. If the number is rejected, the ERROR result is
returned. If three successive Errors are returned, the modem must be
reset by Sierra Wireless AirLink Solutions to allow any further
attempts. The modem permits 99 failures of this command during its
lifetime. After that, the modem becomes permanently disabled.
*PROVISION=MSL,MDN/MIN[,SID][,NID]
Tip: It is recommended to use the Setup Wizard for your carrier to
provision the modem.