Siemens WU P Series, Инструкция по эксплуатации и руководство по установке

Страница: 23 / 40

Programme default settings
en
23
0
Programme default
settings
Programme default settings
°C Temp.
Depending on what stage the
programme is in, you can change the
temperature before and during the
programme.
The maximum temperature that can be
set depending on the model and the
programme that has been selected.
0
rpm
Depending on what stage the program
is in, you can change the spin speed (in
rpm; revolutions per minute) before and
during the program.
Setting 0 (“No spin”)
: The rinsing water
is drained but there is no final spin. The
laundry stays wet inside the drum, e.g.
for items that should not be spun.
Setting - - - (“Rinse hold”)
: Rinse hold
= no final drain. The laundry stays in the
water after the final rinse.
You can select "Rinse hold" to prevent
creasing if the laundry will not be taken
out of the appliance immediately after
the program has ended.
To continue/end the program
~
Page 28
The maximum speed that can be set
depends on the model and program
that has been selected.
û
Finish in
Before starting the programme
, you
can preselect the programme end
("Finish in" time) in hourly increments (h
= hour) up to a maximum of 24 hours.
To do this:
1.
Select a programme.
The programme duration is
displayed for the selected
programme, e.g.
2:30
(hours:minutes).
2.
Touch the
û
Finish in
button
repeatedly until the required number
of hours is displayed.
3.
Select the
A
Start/Reload
button.
The programme starts.
The selected number of hours (e.g.
8h
) is shown in the display panel
and counts down until the
programme starts. The duration of
the programme is then displayed.
Note:
The length of the programme is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme additional settings may also
change the programme duration.
After starting the programme
(if a
窖悸
(Finish in)
û
time has been selected
and the programme has not yet started),
you can change the preselected
number of hours as follows:
1.
Select the
A
Start/Reload
button.
2.
Touch the
û
Finish in
button to
change the number of hours.
3.
Select the
A
Start/Reload
button.