Siemens WT4HY790GB, Инструкция по установке и эксплуатации

Страница: 16 / 48

en
Installation and connection
16
6.
Pull out the condensation container
fully.
7.
Turn the condensation container
180° onto its underside and remove
the stopper that is fitted.Turn the
condensation container back over
and insert the stopper into the
recess in the top of the
condensation container.
8.
Pull the filter out of the lock-in slot
and place it into the recess in the top
of the condensation container.
9.
Slide in the condensation container
until it clicks into place.
The condensation is now discharged via
the drain hose into the waste-water
system or into a wash basin
Note:
If you want to change the
condensation drain back to the
condensation container, carry out all
these steps in reverse order.
Changing the side on which
the door is hinged
Proceed as follows to change
the side on which the door is hinged:
1.
Set the programme selector to the
"Off" position, disconnect the dryer
from the mains and open the door.
2.
Remove the screws from the dryer
and then remove the dryer door.
Note:
Use a T20 (Torx) screwdriver
only. Do not use any other tools to
change the side on which the door is
hinged.