Siemens WT47XKH1GC, Инструкция по установке и эксплуатации

Страница: 30 / 64

en
Appliance settings
30
automatic cleaning cycle. The filter is
cleaned by emptying out the
condensation water. You should still
check the filter regularly for any build-
up, and remove this if necessary.
~
"Cleaning the filter in the
condensation container" on page 51
2
Appliance settings
Appliance settings
You can activate/deactivate the
childproof lock and adjust the basic
settings (e.g. signals).
Childproof lock
Activating the childproof lock prevents
the settings from being accidentally
changed on the control panel.
Activating/deactivating the childproof
lock:
■
Press and hold
Child Lock 3 sec.
w
for 3 seconds.
Note:
The childproof lock will remain
active, even once the appliance has
been switched off. If you wish to change
settings on the control panel when you
turn on the appliance, you will need to
deactivate the childproof lock.
Notification signal
You can activate or deactivate the
notification signal at the end of the
programme. If you activate this setting,
an audible signal will sound once the
programme has ended.
Activate/deactivate the appliance
setting as follows:
Press Signal .
The notification signal at the end of
programme is activated/deactivated.
Note:
If a signal does not sound when
the programme ends even though the
notification signal is activated, you can
change the appliance setting.
Basic settings
You can adjust certain basic settings on
the appliance. To make adjustments,
you first need to
call up the setting
mode
:
1.
Set the programme to the
(
position.
2.
Press
Drying aim
and, at the same
time:
3.
Set the programme to the
0
position.
4.
Release
Drying aim
.
Setting mode is now activated.
The basic settings are assigned to the
following programme positions:
#
+
3
;
#
+
3
;