
Help with the appliance
en
69
Laundry is not dried properly or
is still too damp.
■
After the programme has ended, warm laundry feels damper than it
actually is. Spread out the laundry and let it cool down.
■
Adjust the drying time or increase the degree of dryness. This will
extend the drying time but the temperature will remain the same.
■
Select a timed programme to add extra drying time for laundry that is
still damp.
■
Select a timed programme for a small load.
■
Do not exceed the maximum load for a programme.
■
Clean the moisture sensor in the drum. The sensor may become cov-
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.
■
Drying has been interrupted as a result of a power cut, because the
condensation container is full or because the maximum drying time
has been exceeded.
Note:
Drying is taking too long.
■
The appliance may have fluff in it. This will increase the required dry-
ing time.
– Clean the air duct.
– Run a complete drying cycle with a load weighing more than
3 kg. Make sure that the laundry has not been pre-dried.
Note:
The appliance's automatic self-cleaning function uses the
condensed water from your laundry. If you regularly dry loads weigh-
ing less than 3 kg, there will not be enough condensed water from
your laundry to run the appliance's automatic self-cleaning function.
You should therefore dry loads weighing more than 3 kg on a regular
basis, making sure that the laundry has not been pre-dried.
■
The heat exchanger may have fluff in it.
– Run the basic appliance care programme.
– If you can see fluff in the exposed heat exchanger, clean it care-
fully using a vacuum cleaner.
■
If the air inlet on the appliance is blocked or not fully open, this may
increase the drying time. Make sure that the air inlet remains unob-
structed.
■
If the ambient temperature is lower than 15 °C or higher than 30 °C,
this may increase the drying time and affect the drying result.
■
Inadequate air circulation in the room may increase the drying time.
Make sure the room is adequately ventilated.
Unpleasant odour in the appli-
ance
Run the intensive appliance care programme.
I am unable to connect to my
home network.
■
Wi-Fi is switched off.To connect to your home network, switch on Wi-
Fi.
|
must appear on the display.
■
Wi-Fi is switched on but a connection to your home network cannot
be established.Check whether your home network is available or try
to connect to your home network again.
Содержание WT47X940EU
Страница 75: ...6 ...