Siemens WT47X940EU, Инструкция по установке и эксплуатации, Страница: 29 / 76

Programme settings
en
29
Programme management
After you have set a programme,
various programme management
functions are available to you.
Start delay
Before
the programme starts, you can
set when the programme should be
ready.
1.
Press
B
(Ready in).
2.
Adjust the programme setting until
the required time until the end of the
programme is displayed.
Note:
Once you have set the time
on your appliance, you can set the
programme time using the time.
If you have not set the time, you can
set the programme end in hours and
30 minute increments.
3.
Press
‹
(Start/Pause).
The programme end is now set and
your programme starts after a delay.
Note:
If required, you can still add or
remove laundry.
~
Page 36
Flex start
Activate the
Flex start
function to allow
your smart energy system (Energy
manager) to start your appliance once
your home photovoltaic system is able
to provide sufficient energy or the
energy tariff is good.
Note:
Your smart energy system
(Energy manager) cannot start your
appliance until it is connected to the
appliance.
Adjust the programme setting as
follows:
1.
Press
B
(Ready in).
2.
Adjust the programme setting until
the required time until the end of the
programme is displayed.
Note:
Once you have set the time
on your appliance, you can set the
programme time using the time.
If you have not set the time, you can
set the programme end in hours and
30 minute increments.
3.
Press
‹
(Start/Pause).
4.
Press
Flex start
in the display
message that follows.
5.
Press
}
.
±
appears in the display.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
1.
Press
‹
(Start/Pause).
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
‹
(Start/Pause).
6.
Press
}
.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Note:
For safety reasons, the remote
start is deactivated in the following
cases:
■
Opening the door
■
Pausing the programme
■
Pressing
}
(Remote Start) again
■
Pressing
"
■
Power failure
Note:
If the smart energy system
(Energy manager) does not start your
appliance or remote start has been
deactivated, the programme is
nonetheless started before the set time
period starts and ends when the time
period expires.