
en
Help with the appliance
68
3
Help with the appliance
Help with the appliance
Faults
Cause/remedy
The appliance will not start.
Check the mains plug and the fuses.
Water is leaking out.
■
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
■
If the optional drain hose* is installed, make sure that the drain hose
No power. The door cannot be
automatically opened.
Manually open the door
The appliance is paused but the
drum is turning.
The appliance has detected a high temperature and has started the
CoolDown process. Temperature regulation can take up to 10 minutes.
You can cancel the CoolDown process at any time by opening the door.
The programme will not start
Make sure that:
■
The door is closed.
■
w
has been deactivated
■
You have pressed
‹
(Start/Pause)
Note:
If the programme has been delayed by setting
B
(Ready in)
, the
programme will start later.
Programme duration displayed
changes as drying progresses.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Creasing.
■
Load exceeded or incorrect programme selected for a type of fabric.
All the required information can be found in the programme
table.
■
Remove laundry from the drum as soon as the drying programme
has finished. Creasing occurs when clothing is left in the drum.
Содержание WT47X940EU
Страница 75: ...6 ...