Faults and what to do about them
en
23
3
Faults and what to do
about them
Faults and what to do about them
Emergency release
e.g. in the event of a power outage
Note:
The programme will continue
running when the power supply has
been restored.
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning. Wait until the drum has stopped
turning.
Caution!
Water damage
Any escaping water may cause water
damage. Do not open the washing
machine door if water can be seen
through the glass.
If the laundry has to be removed, the
washing machine door can be opened
as follows:
1.
Switch off the appliance.
2.
Disconnect the mains plug.
3.
4.
Pull the emergency release
downwards with a tool and release.
The washing machine door can now
be opened.
Information on the display panel
Display
Cause/Remedy
Õ
■
Flashes fast + warning signal
: The door was opened and the water level is
too high. Close the door, continue the programme with
‹
button or select
Spin
programme.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
|
■
Flashes
(no water supply): Tap turned on? Water inlet filter blocked? Clean the
water inlet filter.
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required
~
separate installation and cleaning
instruction for water filter.
Water hose kinked or blocked?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:18
Drain pump blocked; clean the drain pump. Clean the drainage hose on the siphon.
E:32
Alternating display with
End
when programme is finished: unbalance problem, spin-
ning phase is aborted.
