en
Additional programme settings
14
û
Finish in
(
û
Finish in)
Before starting the program
, you can
preselect the program end ("Ready in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
1.
Select a program.
The program duration is displayed
for the selected program, e.g.
2:30
(hours:minutes).
2.
Press the
û
Finish in
button
repeatedly until the required number
of hours is displayed.
3.
Press the
‹
button.
The door will be locked.
The selected number of hours (e.g.
8 h
) is shown in the display panel
and counts down until the wash
program starts. The duration of the
program is then displayed.
During the timer count-down
, you can
change the preselected number of
hours as follows:
1.
Press the
‹
button.
2.
Use the
û
Finish in
button to
change the number of hours.
3.
Press the
‹
button.
During the timer count-down
, you can
add or remove laundry as required:
1.
Press the
‹
button.
2.
Open the door and add or remove
laundry.
3.
Close the door.
4.
Press the
‹
button.
Note:
The length of the program is
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
■
Program settings,
■
Detergent dosage (additional rinse
cycles if required due to foaming),
■
Load size/type of textiles (longer
washing for higher load and for
textiles which absorb more water),
■
Imbalances (e. g. due to fitted
sheets) are offset with several start-
ups of spin cycles,
■
Fluctuations in power supply,
■
Water pressure (infeeding speed).
\
Additional programme
settings
Additional programme settings
Note:
You can find possible
programme additional settings in the
overview; these differ depending on the
model.
speed/eco
(
(
¦
)
Button with two possible settings for
adapting the selected program:
■
(
speed
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more
energy than, the selected program,
without the speed/eco setting.
Note:
Do not exceed the maximum
load.
■
¦
eco
Energy-optimised washing by
reducing the temperature while
achieving a washing result that is
consistent with the selected
program, without the speed/eco
setting.
Press the button to do this. First of all,
you can select the
(
speed
setting. If
you press the button again, the
¦
eco
setting is active. The respective symbol
is shown in the display when the setting
is activated.
If you press the button again, no setting
is active.
Rinse+
(
Ô
Rinse+)
Increased water level and additional
rinse cycle, extended washing time. For
areas with very soft water or for further
enhancing the spin result.
Less iron
(
S
Less iron)
Special spin sequence with subsequent
fluffing. Gentle final spin – residual
moisture in the laundry slightly
increased.
