Place and connect
NL
in addition
a hose clamp (24 - 40 mm
diameter, available in specialist shops)
is required to
water drain hose to connect to a siphon.
Attention!
Water damage
The connection points for the
water supply hose and
water drain hose are under high
pressure. To prevent leakage and water
damage, follow the instructions in this
section.
huh
other tool
■
■
Spirit level for leveling Wrench with:
– Width 13 for releasing the transport
locks
– Width 17 for adjusting the feet of
the appliance
Clues
■
In addition to the safety information
listed here, the local water and
electricity supplier have special
requirements.
In case of doubt, have the appliance
installed by a specialist.
Safety Instructions
■
:
Warning
Risk of injury!
■
The device is very heavy. Be careful
when lifting/transporting the device. If
the appliance is lifted by protruding
parts (e.g. appliance door), parts may
break off and cause injury.
Do not lift the appliance by
protruding parts.
If the hose and mains cable are not
routed correctly, there is a risk of
tripping and injury.
Lay hoses and cables in such a way
that there is no risk of tripping over
them.
Installation surface
Note:
The device must be in a stable
horizontal position so that it does not
move.
■
The installation surface must be firm
and flat.
■
Soft floors/carpeting are not suitable.
■
■
Installation on a base or
wooden floor
Attention!
Damage to the device
The device may "walk" and tip/fall off the
base when
centrifugation.
The feet of the appliance must be
secured using mounting brackets.
order no. WMZ 2200, WX 975600, CZ
110600, Z 7080X0.
Attention!
Damage to the device
Frozen hoses can tear/burst.
Do not install the device in areas exposed
to frost or outdoors.
Note:
Installing the device on wooden
beam floors:
■
■
at an angle if possible, On a water-
resistant wooden board (min. 30 mm
thickness) screwed firmly to the floor.
15