Environmental protection
NL
Attention!
Material damage / damage to
the device
Save energy and resources
Cleaning agents and
resources for the
Pre-treating laundry (e.g. stain
removers, pre-wash sprays,
etc.) can cause damage if they
come into contact with surfaces
of the appliance. Therefore
please note:
If you follow these instructions, the
appliance will use less electricity and
water.
Choose programs with low temperatures
and longer washing times, and use the
maximum load capacity
■
Energy consumption and water
consumption are then the most efficient.
Use the most economical program
settings.
■
Do not allow these agents
to come into contact with
the surfaces of the
device.
Clean the device with
only water and a soft,
damp cloth.
Remove if necessary
detergent, spray or other
residue immediately.
■
If you adjust the program settings for
a programme, the display shows the
expected consumption.
■
Depending on the degree of soiling
of the laundry, add detergent ~
page 30.
■
A smaller amount of detergent is
sufficient for light to normal soiling.
Follow the dosage advice of the
detergent manufacturer.
■
Reduce the washing temperature for
lightly and normally soiled laundry.
7
Environmental protection
■
At low temperatures, the device
consumes less energy. For light to
normal soiling, lower temperatures
than indicated on the care label are
also sufficient.
Environmental protection
Packaging/Used device
)
Dispose of the packaging in an
environmentally friendly
manner. This device is labeled
in accordance with the
European Directive 2012/19/EU
on waste
electrical and electronic
equipment (waste electrical and
electronic equipment - WEEE).
The directive defines a
framework for the return and
recycling of used devices and
applies throughout Europe.
Set the maximum spin speed if you want
to dry the laundry in a dryer afterwards.
■
The drier the laundry, the shorter the
program duration during drying, which
means
energy consumption decreases. A
higher spin speed reduces the residual
moisture in the laundry, but leads to a
increased spin noise.
13