Siemens WM14VPH4GB, Руководство пользователя и инструкции по установке

Страница: 57 / 72

Troubleshooting
en
57
Fault Cause and troubleshooting
"E:36 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 50
"E:38 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drum", Page 48
if the fault is displayed again,
▶
→ "Cleaning the drain pump", Page 50
Inlet opening of the rubber gasket is blocked.
▶
→ "Cleaning the intake opening in the rubber gas-
ket", Page 52
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow → Page 53 .
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
lights up. The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 40
Water level is too high.
▶
Start the
Drain
programme.
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
Start/Reload
to start the programme.
flashes. Door is not closed.
1.
Close the door.
2.
Press
Start/Reload
to start the programme.