Siemens WM14VPH4GB, Руководство пользователя и инструкции по установке

Страница: 45 / 72

Home Connect
en
45
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
- Ready In +
to set the re-
quired time.
3.
Press
Start/Reload
.
4.
Press
Remote Start
.
a The display shows and Flex Start
is activated. The appliance waits to
be started by the smart energy
system (energy manager).
a If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a
If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡
Press
Start/Reload
.
¡
Open the door.
¡
Switch off the appliance.
¡
Power failure.
15.5 Activating Wi-Fi on the
appliance
Note:
When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly until
the display shows
On
.
a
Wi-Fi is activated.
Note:
If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
15.6 Deactivating Wi-Fi on the
appliance
1.
Press and hold
Remote Start
for
at least three seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly until
the display shows
OFF
.
a
Wi-Fi is deactivated.
Note:
If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
15.7 Software update
Requirement:
The display shows
UPd
.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 6.
a UPd
appears on the display.
3.
Press
Start/Reload
.
a
The software update is installed.
a If
End
is shown on the display, the
software update is installed.
Note:
The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
15.8 Resetting the appliance
network settings
1.
Press and hold
Remote Start
for
at least 3 seconds.