Sensors
en
21
Removing laundry/switching
off the appliance
1.
Open the washing machine door
and remove the laundry.
2.
Set the programme selector to
Off
.
The appliance is switched off.
3.
Turn off the water tap.
Note:
Not required for Aqua-Stop
models.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Leave the washing machine door
and detergent drawer open so that
any residual water can dry away.
■
Always wait for the end of the
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
■
If the display panel goes off at the
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.
H
Sensors
Se
n
sor
s
Automatic load sensing
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Note:
Place large and small items of
laundry evenly in the drum.
Volt monitor
The automatic voltage control system
detects that the voltage has fallen to an
impermissible value. The colon in the
"Ready in" display flashes on the display
If the supply voltage is stable again, the
colon in the "Ready in" display will stop
flashing.
However, if the fall in voltage causes the
programme to be extended, the dot
flashes in the "Ready in" display.
