Siemens WM10K160IN, Инструкция по эксплуатации и руководство по установке

Страница: 16 / 40

en
Programme default settings
16
Soaking
1.
Pour soaking agent/detergent into
compartment
II
in accordance with
the manufacturer's instructions.
2.
Select desired programme.
3.
Press
Start
/Reload
!
.
4.
After approx. ten minutes, press
Start/
Reload
!
.
5.
After the required soaking time,
press
Start
/Reload
!
again to
continue or change the programme.
Notes
■
Load laundry of the same colour.
■
No additional detergent is required;
the soaking solution is used for
washing.
0
Programme default
settings
Programme default settings
The temperature, spin speed and
programme duration ("Ready in" time)
for all programmes are preset at the
factory.
These are displayed in the display panel
after selecting the programme.
You can change the default settings as
follows.
(Temperature) ° C
(Temperature)
Depending on the programme
progress, you can change the preset
temperature (in °C) before and during
the programme.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The maximum temperature that can be
set depends on the programme which
has been selected.
Overview of programmes
~
Page 13
(Spin speed)
0
(Spin speed)
Depending on the programme
progress, you can change the spin
speed (in rpm; rotations per minute)
before and during the programme.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
Setting – – –
0
: Rinse hold = without
final spin, the laundry remains in the
water after the final rinse.
You can select "Rinse hold" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
The maximum speed that can be set
depends on the model and programme
that have been selected.
Overview of programmes
~
Page 13
(Ready in)
5
(“Ready in” time)
When you select the programme, the
relevant programme duration is
displayed.
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings also change the
programme duration.
Before starting the programme, the
programme end ("Ready in" time) can
be preselected in increments of one
hour (h = hours) up to a maximum of 24
hours.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
Note:
The programme duration is
included in the selected "Ready in" time.