en
Programme default settings
26
0
Programme default
settings
Programme default settings
The programme default settings for all
programmes are preset at the factory
and are displayed in the display panel
after the programme is selected.
You can change the default settings by
repeatedly pressing the corresponding
buttons until the required settings are
displayed in the display panel.
Note:
Pressing and holding the button
automatically runs through the setting
values until the last one. Press the
button once more and you will be able
to change the setting values again.
The available settings vary depending
on the model.
You can find an overview of all settings
available for selection in each
programme on the supplementary sheet
for the operating and installation
instructions.
Temperature
(°C, °C Temp., Temperature)
Depending on what stage the
programme is in, you can change the
set temperature before and at the
beginning of the programme.
Notes
■
The maximum temperature that can
be set depends on the programme
that has been selected.
■
The remaining time may be
increased or decreased according to
the changed temperature values.
Spin speed
(
0
, rpm
0
, Spin speed)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting
‹
: The rinsing water is drained
but there is no spin. The laundry stays
wet inside the drum, e.g. for items that
should not be spun.
Setting
- - -: (Rinse Stop) = no final
spin. The laundry stays in the water after
the final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
"Programme end during Rinse Stop"
Note:
The maximum speed that can be
set depends on the model and
programme that has been selected.
Ready in
(
û
,
û
Finished in, Finish in, Ready in)
Before starting the programme
, you
can preselect the programme end
("Ready in" time) in hourly increments (h
= hour) up to a maximum of 24 hours.
To do this:
1.
Select a programme.
The programme duration is
displayed for the selected
programme, e.g.
ƒ
:
„‹
(hours:minutes).
2.
Press the
Ready in
button
repeatedly until the required number
of hours is displayed.
www.devicemanuals.eu/
