Siemens VS08 series, Инструкция по эксплуатации

Страница: 14 / 138

11
Vacuuming with accessories
Figure
Pull the 4 in 1 tool in the direction of the arrow to remove it
from the tool holder.
a) Crevice nozzle
For vacuuming in crevices and corners.
For difficult to reach places, the 4 in 1 tool can be
extended to two different lengths by pulling out the
crevice nozzle.
䡲
For either length extension, pull the crevice nozzle out
until you hear it engage.
䡲
The crevice nozzle can be pushed back in again by
releasing the telescopic locking mechanism (pressing
it in the direction of the arrow).
b)
Upholstery nozzle
For vacuuming upholstered furniture, curtains, etc.
c) Furniture brush
For window frames, cabinets, profiles etc.
䡲
Fold the upholstery nozzle over in the direction of the
arrow.
䡲
To extend the brush ring, turn in the direction of the
arrow.
Before inserting the 4 in 1 tool into the tool holder,
retract the brush ring and fold the upholstery nozzle
back.
Figure
You can use the parking aid on the back of the vacuum
cleaner if you wish to stop vacuuming for a short time.
Slide the plastic lug on the tool connector into the
groove at the back of the vacuum cleaner.
First switch the vacuum cleaner to »stand-by« mode
(see Figure 9).
When the work is done
Figure
䡲
Switch the vacuum cleaner off and unplug the power
cord from the mains.
䡲
Tug the power cord and let go. The cable then rewinds
automatically.
䡲
To reactivate or deactivate the cable brake, quickly tug
the power cord.
Figure
Press the sliding switch in the direction of the arrow to
release the telescopic tube and slide it together.
Figure
To store or transport the vacuum cleaner, use the storage
aid on the underside of the vacuum cleaner. Stand the
vacuum cleaner up on its end.
Slide the plastic lug on the floor tool into the groove on
the underside of the vacuum cleaner.
17
16
15
14
13
Vacuuming
You have bought an extremely powerful device.
The highest suction setting is therefore only recommended
for heavily soiled, short-pile carpets and hard floors.
Figure
The required suction power can be selected by adjusting the
suction regulator.
䡲
Low
suction range:
For vacuuming delicate fabrics, e.g. curtains.
䡲
Moderate
suction range:
For daily vacuuming of lightly soiled floors.
䡲
High
suction range:
For vacuuming durable floor coverings, hard floors and
for heavily soiled surfaces.
䡲
Turbo range:
For vacuuming stubborn dirt and very heavily soiled sur-
faces.
Figure
By pressing the switch slide too far in the direction of
the arrow, the vacuum cleaner switches off and enters
»stand-by« mode.
=>lowest power setting flashes »blue«
By pressing the switch slide in the opposite direction,
the vacuum cleaner switches back on again.
Figure
While the vacuum cleaner is in use, the Electromatic
brush can be switched on or off by pressing the switch
button.
Floor tool with carpet lifter and locking collar
Figure
Adjusting the floor tool:
a) For vacuuming rugs and carpets
=>
b) For vacuuming hard floors =>
Figure
When you pull the floor tool backwards, the rug is lifted,
allowing you to clean underneath its edge.
12
11
10
9
8
en
Downloaded From Vacuum-Manual.com Manuals