Siemens TI355F09DE, Инструкция по эксплуатации

Страница: 51 / 136

Trouble shooting
en
51
The brewing unit cannot be
removed.
The brewing unit is not in the
removal position (e.g. frost pro-
tection activated).
Switch the appliance on again.
The appliance cannot be oper-
ated, display messages chang-
ing.
The appliance is in demo mode. Hold
k
button for at least 5 seconds
to deactivate demo mode. Remove the
water tank, fill with fresh water and
re-insert.
The grinder will not start. The appliance is too hot. Disconnect the appliance from the
mains and leave to cool down for
1 hour.
Display shows "Close door"
despite door being closed.
The door is not closed properly. Press the door firmly closed.
The appliance is too hot.
Disconnect the appliance from the
mains and leave to cool down for
1 hour.
Display shows: "Empty trays"
despite empty drip tray - what
to do?
Emptying is not detected when
the appliance is off.
When the appliance is switched on,
remove and re-insert the drip tray.
Display shows "Fill water tank"
despite full water tank.
Water tank wrongly inserted. Insert water tank correctly.
Carbonated water in the water
tank.
Fill the water tank with fresh tap water.
Float is stuck in the water tank. Remove the water tank and clean thor-
oughly.
New water filter not rinsed
according to the instructions.
Rinse the water filter according to the
instructions and then switch on.
Air in the water filter. Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~
"Inserting or replacing a water
filter" on page 42
Water filter is old. Insert a new water filter.
Limescale deposits in the water
tank can block up the system.
Thoroughly clean the water tank and
start calc'nClean.
~
"Calc’nClean
service programme" on page 48
Display shows "Fill water tank"
and LEDs flashing.
Water tank is missing or not
inserted correctly.
Insert water tank correctly.
The pipe system in the appli-
ance is dry.
Fill the water tank with fresh tap water.
Do not fill with carbonated water.
Air in the water filter. Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.