Installation Instructions
Document No. 540-149
September 2, 2008
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as
design improvements are introduced. TALON is a registered trademark of Siemens Building Technologies, Inc. Other product or company names
mentioned herein may be the trademarks of their respective owners. © 2008 Siemens Building Technologies, Inc.
Siemens Building Technologies, Inc.
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
U.S.A.
Your feedback is important to us. If you have
comments about this document, please send them to
Document No. 540-149
Country of Origin: U.S.
Page 4
of 4
Accessories
Review Table 1 to verify that you have the appropriate mounting hardware.
For retrofit installations, normally follow the method used by the pre-existing device. You may need to replace existing
mounting hardware. Always mount the sensor vertically.
Table 1. Mounting Accessories.
P/N Description
Used
For
Reference
182-621E Gym Guard Kit, satin
chrome
gyms and similar environments requiring a guard.
(Incompatible with adapter bases and the extender
ring.)
155-222P25
(TB 193)
182-683
Metal (and Wood) Stud
Mounting Bracket (pkg. 5)
Single-sensor rough-in installations. Kit includes
locator.
129-057
182-685 Spring
Clips:
Finished
Drywall Mounting Kit
(10 pack)
Drywall mounting.
129-073
192-506
Electrical Box Adapter Plate
Assembly Kit (pkg. 5)
Electrical boxes mounted flush with the wall and for
gyms and similar environments requiring a guard.
(Also see
544-782
.)
Figure 5
192-860
Finish Plate Kit 1 Gang 1
Sensor; stainless steel
Single-sensor, low-cost mounting. Plate is 3.7 × 5.1
inches (9.5 × 12.9 cm)
155-252P25
(TB 238)
536-666 Mounting
Strap
Standard
light switch plate (field-supplied) to mount
sensor on 2 × 4 electrical box
540-040
540-237
544-782B Single Adapter Base
Mounting Kit, white
2 × 4 boxes, all single sensor installations on walls
with oversized holes, paint lines, etc., that need to be
covered, and on exterior brick/cement-type walls. Kit
includes Electrical Box Adapter Plate Assembly
(192-495. Adapter base is 3-1/2 × 5 inches
(8.8 × 12.7 cm).
Figure 5
544-783B Double Adapter Base
Mounting Kit, white
4 × 6 boxes and all double sensor installations on
walls with oversized holes, paint lines, etc., that need
to be covered, and on exterior brick/cement-type
walls. Kit includes two mounting plates (192-720).
Adapter base is 5 × 7 inches (12.7 × 18 cm).
Figure 5
544-784
Non-conduit Rough-in Kit,
Double
Double-sensor non-conduit rough-in installations. Kit
includes locator.
540-784
544-785B Extender Ring Kit, white
Exterior brick or cement-type walls; fits to back of
sensor base plate
—
544-800
Universal Adapter Kit
Retrofitting a previous horizontal installation to a
vertical one, or when the screw spacing does not fit
the electrical box adapter plate. Kit includes multi-
slotted adapter plate.
Figure 5
981-344
Electrical Box Cover Plate
Kit
2 × 4 box rough-ins. Kit includes locator and
connector.
—
