en
Installation and connection
38
Fresh water connection
1.
Connect the fresh-water connection
to the tap according to the
installation instructions with the
enclosed parts.
Ensure that the fresh-water
connection is not kinked, crushed or
twisted.
2.
When replacing the appliance,
always use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water; hot water max. temperature
60 °C.
Warm water connection *
Warm water connection
* depending on model
The dishwasher can be connected
to cold or hot water up to max. 60 °C.
Connection to hot water
is recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with circulation
line.
This will save energy and time.
The hot water setting
‘
:
‹‚
allows you
to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
1.
Open the door.
2.
Switch on ON/OFF switch
(
.
3.
Hold down programme button
#
and press START button
)"
until
•
:
‹
... is indicated on the digital
display.
4.
Release both buttons.
The LED for button
#
flashes and
the digital display
8
displays the
factory setting
•
:
‹…
.
5.
Press programme button
#
until
the factory set value
‘
:
‹‹
is indicated on the digital
display
8
.
Downloaded from DishWasher-Manual.com Manuals
