Siemens SITRANS FUH1010, Инструкция по эксплуатации товара, Страница: 63 / 264

Connecting
5.6 Sensor Installation
FUH1010 IP65 NEMA 4X Precision Volume
62
Operating Instructions, 01/2013, A5E32122003-AA
11. Wrap the Mylar spacing guide around the pipe so that the left edge is against the sensor
edge mark (see "C" above). Arrange so that one end overlaps the other by at least three
inches. Trim to fit if necessary, but be sure not to trim at the overlapping end in order to
keep it square.
12. Realign left edge of the guide with the sensor edge mark. Line up both vertical edges of
the guide and ensuring that it is snug around the pipe, mark along the overlapping edge.
13. Remove Mylar spacing guide and lay it out on a flat surface. Either measure the exact
distance half-way between the overlap edge and the mark at the overlap, or fold the
guide from the overlap edge to overlap mark and draw a line at the fold or halfway point.
① ③
Overlap Edge Spacing Guide
②
Mark (or fold) exactly at half-way point
④
Circumference
Figure 5-15 Finding the Halfway Distance
14. Reinstall the spacing guide; its left edge abutting the sensors edge mark on the pipe and
the overlapping edge in line with the dot (now a line) on the pipe (see "C). Tape it in this
position on the pipe. Take the second frame and place it against the edge of the guide
with its tapered roller centered on the center mark on the guide.
15. Temporarily position the frame (in the 3 o’clock position opposite the mounted frame -
see below) where it will be mounted. Ensure that this is a smooth area without any raised
spots (seams, etc.). Mark a generous area of 13 mm (1/2-inch) all around the mounting
frames with a pencil or chalk. Remove the frame and the Mylar guide.
①
9 o'clock Sensor
②
3 o'clock Sensor
Figure 5-16 Aligning the Sensors for Direct Mode operation (End View)