SIREMOBIL Compact
Register 5
RXR2-130.061.02
Page 14 of 22
Siemens AG
System Manual
Rev. 03
10.03
CS PS 24
Medical Engineering
5 - 14
Adjustments / Programs
•
Click "OK". The new position values for camera rotation will be stored to the disk.
•
Switch the SIREMOBIL Compact OFF and ON again.
•
Check the adjustments again. In the 0° position, the object image must correspond to the
one in Fig. 4.
Calibrating the area dose product measurement device
5
Calculating the CONSTANT parameter (Qt * Kg)
5
•
Read and record the Kg value shown on the electronics unit of the area dose product
measurement device.
•
Read the Qt value on the dose chamber of the area dose product measurement device.
•
Multiply these values and record them. The resulting value is the CONSTANT (QT*Kg)
value to be programmed.
Programming
5
•
Connect the service PC to the serial interface on board D1.
•
Start the service program.
•
Select the Adjustment, Parameter menu.
•
In the Combo box "Parameter Groups", select "Diamentor" .
•
Click on "Get from Unit".
•
The Parameter "1. Diamentor Existing" must be on YES .
•
Select parameter "2. Constant (Qt * Kg)" .
•
In "Value Actual:" field, enter the parameter you have calculated.
•
Click on "Set Value".
•
Click on "Put to Unit" .
•
Click on "Save to File".
This adjustment is used to calibrate the area dose product mea-
surement device of the SIREMOBIL Compact display.
You must exit the service program with "Logoff" and "Quit" to
store the modified parameters to disk as a new file.
NOTE
NOTE
