Siemens SIMOTICS HT Series, Инструкция по эксплуатации и установке

Страница: 63 / 128

Electrical connection
6
6.1 Safety instructions relating to the electrical connection
Observe the following when carrying out any work on the machine:
● Comply with the general safety instructions (Page 13)
● Comply with the applicable national and sector-specific regulations.
● When using the machine within the European Union, comply with the specifications laid
down in EN 50110‑1 regarding safe operation of electrical equipment.
Material damage as a result of connection parts coming loose
If you use fixing elements made from the wrong material or apply the wrong tightening torque,
this could impair current transfer or cause connecting parts to become loose. This could result
in material damage to the machine or even in total failure, which could in turn lead indirectly
to material damage to the system.
● Tighten the screwed connections to the specified tightening torques.
● Observe any specifications regarding the materials from which fixing elements must be
made.
● When performing servicing, check the fastenings.
Note
Service Center
If you require support when electrically connecting up the machine, please contact the Service
Center (Page 117).
6.2 Basic rules
The following generally applies to electrical connections:
● Ensure that there is a safe and reliable PE ground connection before starting any work.
● The connecting cables can be sealed and secured at every cable entry point into the
terminal box.
● Lay the connecting cables and in particular the PE conductor in the terminal box in an open
arrangement so that chafing of the cable insulation is prevented.
SIMOTICS HT Series HT-direct 1FW4...1......A
Operating Instructions 11/2018
63