5
Using the Command Interface
62
CP 343−2 / CP 343−2 P AS−Interface Master
Release 08/2008
C79000−G8976−C149−04
5.2.1
Set_Permanent_Parameter
Meaning
With this call, a parameter value for the specified AS-i slave is configured on the
CP 343-2. The value is stored permanently in the EEPROM of the CP 343-2.
The configured parameter is
not
transferred immediately by the CP 343-2 to the
AS-i slave. The configured parameter value is only transferred when the AS-i slave
is activated after turning on the power supply on the CP 343-2.
This call is not permitted for AS-i slaves that comply with the AS-i slave standard
profile 7.4. For these AS-i slaves, the AS-i master handles the AS-i slave
parameter assignment itself. In this case, the configured parameters are always
set to F
H
.
Notice
If you configure the AS-i slaves with HW Config, using the call described here is
generally unnecessary
If you do use the call, you will overwrite the corresponding configuration data
originating from the button configuration or the configuration set with HW Config.
Structure of the Job Data in the Send Buffer
Byte
Meaning
Bit 7
Bit 4
Bit 3
Bit 0
0
Command number: 00
H
1
Slave address
2
0
Parameter
