Private Communication Systems
Mobile Phones
General Information
The S6 Power is a consumer handset technically based on E10. It is also available
as a dualrate version (S6 D Power).
Mechanical Concept
Note: All part numbers refer to mechanical drawing in section
4.1!
The S6 Power consists of two boards, the RF & Control module (1010) and the user
interface (1020).
The connection between those two boards is not made by a normal connector with
plug-in contacts, but by a special interconnector (1090) embedded into a shielding
frame (1060). This interconnector is upholding the connection through the pressure
implied on it by the housing.
Be careful when assembling the interconnector. Avoid any kind of dust or dirt
because it will affect the contacts of the interconnector.
The only removable part on the user interface is the ringer gasket (1080) which is
needed to increase the ringer volume.
Furthermore there is a RF-plug on the user interface which has to be plugged into
the appropriate connector on the RF & control module. This conection is very
essential because it is the RF signal from / to the internal antenna.
The shielding is done by the lower case shell (1050) which is covered with a
conductive material, so no additional shielding screen is necessary.
The antenna (1130) is directly screwed into the lower case shell.
V1.2
Page
3
of 18
PN MP ST
D. Schnoor
4/98
