Siemens RUGGEDCOM MX5000RE, Справочное руководство

Страница: 106 / 148

Chapter 7
Examples
RUGGEDCOM NETCONF
Reference Guide
94 Retrieving all IP Addresses from the Running Configuration
Section 7.18
Retrieving all IP Addresses from the Running
Configuration
In this example, a single <rpc> request retrieves all IP addresses from the running configuration on a device.
The following is the typical procedure for querying data from the running configuration.
•
Request the data from the running configuration:
<rpc message-id="2" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<get-config>
<source>
<running/>
</source>
<filter type="subtree">
<ip xmlns="http://ruggedcom.com/ns/rmf_ip">
<ipv4>
<address></address>
</ipv4>
</ip>
</filter>
</get-config>
</rpc>]]>]]>
Section 7.19
Retrieving the Active Routes on a Device
In this example, a single <rpc> request retrieves the active routes from the running configuration on a device.
The following is the typical procedure for querying data from the running configuration.
•
Request the data from the running configuration:
<rpc message-id="2" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<get>
<filter type="subtree">
<routing xmlns="http://ruggedcom.com/ns/rmf_routing">
<status>
<ipv4routes>
<active-routes>
<destination>default</destination>
<gateway></gateway>
<interface></interface>
<type></type>
</active-routes>
</ipv4routes>
</status>
</routing>
</filter>
</get>
</rpc>]]>]]>