Siemens RUGGEDCOM i803, Руководство по установке

Страница: 23 / 40

Device Management
3.2 Configuring the Device
Pin
RJ45 Male DB9 Female
Name Description Comment
8 7 RTS
b
Read to Send
a
The DSR, RI and DTR pins are connected together internally.
b
The CTS and RTS pins are connected together internally.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM i803 console and Web interfaces via the device's IP
address. For more information about available ports, refer to " Communication Ports
(Page 17)" .
Note
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
3.2 Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM i803 interface. For
more information about configuring the device, refer to the "RUGGEDCOM ROS
Configuration Manual" associated with the installed software release.
3.3 Inserting/Removing the MicroSD/MicroSDHC Card
The RUGGEDCOM i803 accepts a microSD/microSDHC card to support the following
features:
• Configuration update and backup
• Redundant firmware image
• Greatly expanded logging capability
• Fault-tolerant firmware update
NOTICE
Configuration hazard – risk of data loss.
The microSD/microSDHC card must not be removed or replaced during normal
operation of the device. Make sure the device is powered down before removing or
inserting the card.
NOTICE
Mechanical/electrical hazard – risk of damage to the microSD/microSDHC card.
• Do not expose the microSD/microSDHC car to extreme temperatures or
humidity.
14
RUGGEDCOM i803
Installation Manual, 04/2022, C79000-G8976-1005-07