2/3
Operating Instructions
CB1B1424en_01 / 2013-07-05
Siemens Building Technologies
Are your rooms too warm/too cold?
+
–
Press
+
or
–
to increase or decrease the
room temperature setpoint in increments of
0.5 °C/1 °F. Proceed as follows:
•
Press
+
or
–
to change the setpoint
temporarily.
Press
to save the setting or wait for
the program to exit automatically
•
To permanently change the temperature
setpoints, use parameters P05 and P07.
To lock the setpoints, use parameters
P06 and P08
Does symbol
appear on the display?
Symbol
is displayed when the batteries are low.
Replace them with 2 new alkaline batteries type AAA.
Proceed as follows:
•
Get 2 new alkaline batteries type AAA
•
Remove the battery holder and then the batteries.
Insert the new batteries and, within 1.5 minutes,
replace the battery holder
•
Ensure the exhausted batteries are disposed of
correctly, in compliance with environmental
requirements
Do you want to pair transmitter and
receiver?
+
–
Learn
The RDD100.1RF communicates with the
RCR100RF at a frequency of 433 MHz.
To pair transmitter and receiver, proceed as
follows:
RCR100RF receiver setting:
1) Press and hold the
LEARN
button on the
reveiver for at least 3 seconds and then
release it.
2) Red and green LEDs flash alternately to
indicate that the receiver is in learning
mode.
RDD100.1/RF transmitter setting:
3) On the transmitter, set the parameters
(refer to section "Do you want to change
parameters?").
4) Check to ensure that parameter P19 is not
0, because this would mean that the
wireless function is disabled. By default,
parameter P19 is 1.
5) Proceed to parameter P20. Press
and
parameter P20=0 (OFF) flashes.
Adjust the value by pressing
+
to change
to P20=1 (ON), then press
to confirm.
6) During wireless learning, the LCD displays
"rF" and "Lrn". Wait for time out, and the
transmitter exits the parameter setting
mode.
Successful wireless learning:
7) The green LED on the RCR100RF flashes
for 10 minutes to indicate that the receiver
has successfully completed wireless
learning.
Recommendation:
8)
Additional test to ensure the wireless
signal is fine:
On the RDD100.1/RF, change the
operating mode by pressing
or
change the setpoint by pressing
+
or
–
.
On the RCR100RF, the green LED should
flash for 3 seconds before changing to
constantly green. At the same time,
observe your radiator, boiler or heater
indication (if it has one) to ensure that it
changed the operating mode.
9) If step 7 or 8 is working fine, this means
you have succesfully paired the units.
Unsuccessful wireless learning:
10) If the RCR100RF fails to receive wireless
data, the red LED starts to flash **.
Repeat steps 1 to 8 until pairing is
successful.
!
Note:
Always start receiver learning before starting
pairing with the transmitter.
The units must be placed such that trans-
mitter and received signals have limited
external wireless interference.
**In normal operation, if a drop in wireless
communication occurs due to unforseeable
noise, just leave the receiver and it will
recover automatically.
The pairs are saved even if there is a power
shut down. Communication restarts
automatically after several minutes without
any user action.
