P/N 315-095965-8
Siemens Industry, Inc.Building Technologies DivisionFlorham Park, NJ
Siemens Building Technologies, Ltd.Fire Safety & Security Products2 Kenview BoulevardBrampton, OntarioL6T 5E4 Canada
Страница 1: ...ses this does not need to be changed If COM 2 is not available Installation Instructions Model NCC 1F NCC G XNET Interface use Table 1 to select the desired COM port Be sure to configure the NCC G computer to use the same port and IRQ for XNET communications See Figure 1 for the location of the jumpers Figure 1 NCC 1F Module Board TABLE 1 CONFIGURING THE NCC 1F COM JP1 JP2 ADDRESS JP3 IRQ 1 A C 3F...
Страница 2: ...T The XNET connections are made on terminals 1 4 of the terminal block on the rear of the NCC 1F The primary pair or network A is on terminals 1 and 2 The secondary pair or network B is on terminals 3 and 4 For Style 4 networks install a 120 ohm EOLR on terminals 3 and 4 See Figure 2 for wiring details For Style 7 networks connect to both the primary and secondary pairs See Figure 2 for wiring det...
Страница 3: ...NCC 1F Ground fault detection must be enabled at a NIM 1R 1W or NIC C Select one and only one NIM 1R 1W or NIC C in the system where the ground fault is to be detected You must locate the NIM 1R 1W in a cabinet with either an MMB SMB or a PSR 1 See Figure 3 for the wiring diagram If the XNET is divided into multiple sections of copper wire using fiber optic segments ground fault detection can be e...
Страница 4: ...P N 315 095965 8 Siemens Industry Inc Building Technologies Division Florham Park NJ Siemens Building Technologies Ltd Fire Safety Security Products 2 Kenview Boulevard Brampton Ontario L6T 5E4 Canada ...
