Siemens INSYS Pocket ISDN-TA, Руководство по эксплуатации

Страница: 17 / 44

Configuring the POCKET ISDN-TA 11
with the prefix AT and are terminated with < ↵ >. Corrections in a command line are
done with <BACKSPACE>. A command line has a maximum of 80 characters. The
command line is automatically cancelled by longer input. Blanks are ignored,
capital/small letters are not significant.
The parameter settings of the POCKET ISDN-TA obtained when using the AT
commands can be permanently stored (AT&W) and are not lost by resetting or by
leaving the AT command mode.
To enter the AT command mode during an active data connection you must use
the following sequence ("Escape sequence"):
at least 1 sec pause <+><+><+> 1 sec pause
The time gap between all three plus signs may not exceed 1 sec.
The escape sequence is transmitted transparent to the remote device.
Supported commands:
A/ Repeat last command line
This command repeats the commands of the last entered command line.
Note: No prefix
AT is required.
A/
A Accept incoming call
Using this command you can accept an incoming call, if automatic call
acceptance is not set (Register S0 = 0). An incoming call is displayed by the
message “RING“ or the code “2“.
Must be the last command in an AT command line.
ATA[//<
UUS1data >]
UUS1data transmitted data with UUS1 signalling
B B channel protocol
Transmission protocol for data communication in the B channel.
ATB0 : V.110 asynchronous (i.e. for BBS access)
ATB3 : HDLC async to sync conversion (PPP asynchronous, single link PPP,
default)
(i.e. for Internet / dial-up network
access)
ATB4 : HDLC transparent (octets are packed into HDLC frames)
ATB5 : Byte transparent (raw B channel data)
ATB10 : X.75-NL (i.e. for BBS access)
ATB13 : V.120 (for AOL/CompuServe access)
ATB20 : X.31 B channel (X.25 B channel, option)