Extended maintenance work
4.5 Changing the mounting type
SIMATIC IPC277D/E 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 11/2017, A5E35751762-AC
19
4.5
Changing the mounting type
This section describes the conversion of a stand-mounted device into a support arm device.
The conversion of a support arm device into a stand-mounted device takes place in the
same manner.
Procedure
1.
Swap the position of the front and rear panel as shown in the figure below.
2.
Turn the rear panel by 180°.
3.
Only for devices with operator controls: Remove the adhesive tape (X) of the flat ribbon
cable as shown in the figure below.
4.
Only for devices with operator controls: Place the flat ribbon cable from the front on the
rear panel, and attach the adhesive tape (X) in its original position as shown in the figure
below.
