Siemens HB56 1 Series, Инструкция по эксплуатации

Страница: 17 / 36

17
Installing
Follow steps 2 to 4 with doors that have two glass panels.
When installing, ensure that the "right above" inscription on the
lower left part is inverted.
1.
Insert the glass panel by tilting it backwards (Figure A).
2.
Insert the upper glass panel on both mounts by tilting it
backwards. Ensure that its smooth surface is facing
outwards. (Figure B)
3.
Fit and tighten the cover.
4.
Refit the oven door.
Once the glass panels have been correctly fitted, the oven is
ready to use.
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Error messages
When the display panel shows an error message with “ , press
the 0 button. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
:
Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
%
$
Fault Possible cause Solution/advice
The oven does not work. The fuse has blown. Check the condition of the fuse in the fuse box.
The display panel shows
‹
:
‹‹
Power cut. Set the time once more.
The oven does not heat or it is not possi-
ble to set the selected type of heating.
The heating type is not recog-
nised.
Reprogram.
The oven does not heat up. The tempera-
ture display shows a small frame.
The oven is in demo mode. Disconnect the fuse in the fuse box and connect it
again after at least 20 seconds. Within the next
2 minutes, hold the button
h
in for 4 seconds until
the indicator no longer displays the square.
After pushing the button s , the display
panel displays
Ÿ©
The side walls inside the oven are
not self-cleaning. The clean func-
tion cannot be used.
The clean function can only be programmed with
the button s if the appliance is equipped with
self-cleaning side walls and the clean function is
activated in the basic settings. See the Clean func-
tion and Basic settings chapters.
The display shows ”‰ .
The automatic shut off function is
activated.The oven will stop heat-
ing.
Press any button.
Error message Possible cause Solution/advice
“‹‚‚
A button has
been pressed
for too long or
has got stuck.
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.