Siemens HB43.S SERIES, Инструкция по эксплуатации

Страница: 11 / 24

11
Hanging the door
Rehang the door by following the same steps but in reverse
order.
1.
When refitting the door, check that both hinges are
positioned exactly inside their respective openings (picture
A).
2.
The bottom groove of the hinges must fit snugly on both
sides.
The door may be left crooked if the hinges are not mounted
properly.
3.
Reclose the attachment levers (picture C). Close the oven
door.
:
Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.
Fitting and removing the glass panels
The glass panels of the oven door can be removed to make
cleaning easier.
Dismantling
1.
Unhook the oven door and position it on a cloth with its
handle pointing downwards.
2.
Unscrew the upper cover from the door cover. To do this,
unscrew the right and left-hand side screws (figure A).
3.
Lift and remove the top glass panel (figure B).
In doors with three glass panels, the following step will also be
necessary:
4.
Remove the lower glass (figure C).
Clean the glass panels using a glass cleaning product and a
soft cloth.
Do not use abrasive or corrosive cleaning products, glass
scrapers, or hard metal scourers as these could damage the
glass.
Installing
Follow steps 2 to 4 with doors that have two glass panels.
1.
Insert the lower glass panel by tilting it backwards (figure A).
When fitting the glass, ensure that the marking "right above"
at the bottom left-hand side is upside down.
2.
Insert the upper glass panel backwards by tilting it with the
smooth surface facing outwards.
3.
Fit and tighten the cover.
4.
Hang the oven door.
Once the glass panels have been correctly fitted, the oven is
ready to use.
% $
&
% $
&
$