21
Quick Start Guide
Gigaset SX685 WiMAX / de-en / A31008-N917-R101-2-ZD43_23-10-2008 / qig_SX686_685.fm / 23.10.2008
Te
m
plat
e 2004
_12
_27
This user guide assumes that installation of the outdoor antenna has been completed.
Connecting and activating the Gigaset SX685 WiMAX
Installation overview
1. If you use the outdoor antenna, have it installed by a radio and television technician.
Connect the antenna cable from outside to the Gigaset SX685 WiMAX.
2. Make sure that an Ethernet network card is installed in the PCs you want to connect
to the Gigaset SX685 WiMAX. The installation is described in the user guides for
these products.
3. Then make the necessary connections (PCs, phones) on the Gigaset SX685 WiMAX
and activate the device.
4. Before the PCs can communicate with the Gigaset SX685 WiMAX and with each oth-
er in a local network, you may have to adapt your network settings (see page 25).
5. Then configure the Gigaset SX685 WiMAX to activate the device's Internet access
(refer to the section entitled "Making the basic settings" on page 25). To do this you
will need the access data for your Internet service provider.
W
3.5 GHz versions should be used for the European Economic Area.
The following requirements apply:
All the external antennas used for this product must undergo a confor-
mity assessment procedure.
The 3.5 GHz antennas listed here meet the European requirements and
guarantee the functionality of the complete system.
During the conformity assessment procedure it was ensured that the SAR
limits set down in directive 99/519/EC are observed. Verification was per-
formed using EN 50385.
The outdoor antenna must be installed and put into service by a qualified
electrician.
The notes in the enclosed installation instructions must be followed
For experienced users
The default settings of the Gigaset SX685 WiMAX for LAN configuration are:
– IP address: 192.168.2.1
– Subnet mask: 255.255.255.0
