Siemens GIGASET S88H, Руководство пользователя

Страница: 8 / 31

7
First steps
Gigaset S88H / EN for China / A31008-M1951-Y101-2-5D19 / starting.fm / 27.7.09
Ve
rs
ion 4,
16
.09.
2005
Manual registration of Gigaset S88H
If the handset does not activate automati-
cally when the batteries are fitted, you
must first charge the batteries.
You must activate manual registration of
the handset on both the handset and the
base station.
Once it has been registered, the handset
returns to idle status. The handset's
internal number is shown in the display
e.g.
INT 1
. If not, repeat the procedure.
On the handset
v
¢
Ð
¢
Handset
¢
Register H/Set
~
Enter the system PIN of the
base station (the default is
0000) and press
§OK§
. Base 1
flashes in the display.
On the base station
Within 60 sec. press and hold the registra-
tion/paging key on the base station
(approx. 3 sec.).
Headset socket
You can connect various headset types
(with 2.5 mm jack connector).
A compatibility list of tested headsets can
be found on the Internet at
www.plantronics.com/productfinder.
Charging batteries
¤
Plug the mains adapter of the charging
cradle into a mains power socket.
¤
Place the handset in the cradle with the
display facing forward.
To charge the batteries, leave the handset
in the charging cradle. If the handset is
activated, the flashing battery icon
e
in
the top right of the display indicates that
the batteries are being charged. During
handset operation, the battery icon indi-
cates the charge status of the batteries
(page 1).
Initial charging and discharging of
batteries
The correct charge level can only be dis-
played if the batteries are first fully
charged and discharged.
¤
To do this, leave the handset in the
charging cradle without interruption
for five hours.
¤
Once the batteries are fully charged,
remove the handset from the cradle
and do not put it back again until the
batteries are fully discharged.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and reinsert
them.
u
The batteries may warm up during
charging. This is not dangerous.
u After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
Please note:
– Automatic registration is not possible when
the base station to which you wish to regis-
ter the handset is being used to make a call.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work,
you will have to register the handset manu-
ally.
Please note:
– The handset should only be placed in a
base station or charging cradle that is
designed for it.
– The handset will automatically switch on if
it is placed in the charging cradle.
– After the first battery charge and dis-
charge, you may place your handset in the
charging cradle after every call.