Siemens ET6..TE.., Инструкция по эксплуатации

Страница: 12 / 16

12
Cleaning and care
The information in this section provides help on how best to
care for your hob.
Suitable maintenance and cleaning products can be purchased
from the after-sales service or in our e-Shop.
Ceramic
Clean the hob after each use. This will prevent spills from
burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for ceramic. Follow
the cleaning instructions on the packaging.
Never use:
■
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■
Harsh cleaning agents such as oven spray or stain remover
■
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
Ground-in dirt can be best removed with a glass scraper,
available from retailers. Please note the manufacturer's
instructions.
You can also obtain a suitable glass scraper from our after-
sales service or from the e-Shop.
Hob surround
To prevent damage to the hob surround, please observe the
following instructions:
■
Use only warm, soapy water.
■
Do not use harsh or abrasive agents.
■
Do not use the glass scraper.
Rectifying faults
Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
Indicator Fault Action
Blank There is no power supply. Check the household fuse for the appliance. Check whether there is a power
cut by trying other electronic appliances.
“
is flash-
ing
The controls are damp or an object is
resting on them.
Dry the controls or remove the object.
Ҥ
+
number
Electronic fault. Switch the appliance off and back on again after about 30 seconds using
either the household fuse or the circuit breaker in the fuse box. Contact the
after-sales service if this appears in the display again.
”ƒ
The electronics have overheated and
have switched off the corresponding
hotplate.
Wait until the electronics have cooled down sufficiently. Then touch a control
for the hotplate.*
”…
The electronics have overheated and
have switched off all hotplates.
Wait until the electronics have cooled down sufficiently. Then touch any con-
trol.*
”‰
The hotplate was in operation for too
long and has switched itself off.
You can switch the hotplate back on again immediately.
* Do not place hot pans close to or on the control panel