Siemens EH675MV17E, Инструкция по эксплуатации

Страница: 11 / 21

10
Flexible zone
This may be used as a single zone or two individual zones
depending on the cooking needs in each situation.
It consists of 4 independently-controlled inductors. When the
flexible zone is working, only the zone covered by the cookware
is activated.
Advice on using cookware
To ensure that the cookware is detected and heat is distributed
evenly, correctly centre the cookware:
Warnings
When using cookware of a different size or made of a different
material, noise and vibrations that do not affect the correct
working of the zone may occur.
Consisting of two independent zones
The flexible zone can be used normally as two independent
hotplates.
How to activate
See “adjusting the hotplate“ section.
As one hotplate
To use the entire hotplate with all individual zones.
How to activate
The hob must be switched on.
1.
Place the cookware and press the
þ
symbol. The
Nþ
indicator lights up.
The flexible zone has been activated.
2.
Then select the desired power level by sliding your finger
over the programming zone until the desired power level
lights up.
The flexible zone is switched on.
Changing the power level
Select the flexible zone by pressing the þ symbol and change
the power level in the programming zone.
Adding more cookware
Press the
þ
symbol. The new pan will be detected and the
previously selected power level will be maintained.
Note:
If the pan on the hotplate that is switched on is moved or
removed, the hob will perform an automatic search and the
previously selected power level will be maintained.
To deactivate
Set it to ‹ in the programming zone.
Return to using two hotplates
Select one of the two hotplates of the flexible zone and set to
‹
.
Note: When a hob is switched off and later switched on again,
the flexible zone will again be used as two hotplates.
As one hotplate
Diameter less than or equal to 13 cm
Place the cookware on one of the four posi-
tions shown in the image.
Diameter greater than 13 cm
Place the cookware on one of the three
positions shown in the image.
If the cookware takes up more than one hot-
plate, place it at the top or bottom edge of
the flexible zone.
As two independent hotplates
The front and back hotplates, each with two
inductors, can be used independently by
selecting the necessary power for each
one. In this case, it is recommended to only
use one pan on each hotplate.
To obtain maximum power with the
Powerboost Function, place the
cookware in the centre of the flexi-
ble zone when used as a single hot-
plate.
On hobs with more than one flexible
zone, it is not recommended to use
several zones at the same time for a
single pan.