Siemens ECOFAST, Руководство пользователя

Страница: 19 / 77

Installation of Motor Starters
ECOFAST Motor Starters
2-2
GWA 4NEB 950 0562-12
2.1 Setting the address
AS-i slave profile
Table 2-1: AS-i slave profile
Requirements
To be able to set the address you need a device such as the addressing and
diagnostic unit (Order No.: 3RK1904-2AB00).
The valid addresses are 1 to 31. Use each address only once.
Note
Motor starters with product status smaller than 10 can be readdressed a
maximum of 15 times. After the 15th time, the last valid address is retained.
Table 2-2: Setting the address via the addressing socket
Motor starter
Order No.
I /O
configu-
ration
(hex) ID Code
(hex) ID1 Code
(hex) ID2 Code
(hex)
of product status
1)
smaller 10 from 10
3RK1 323-2AS51-1AA0 7 D F F 0
3RK1 323-2AS51-1AA3 7 D F F 0
1)
The product status is printed below the addressing socket
Step Procedure
1
If you intend to address the motor starter via the addressing socket,
switch off the AS-i supply voltage. This is necessary for reasons of
system safety.
2 Unscrew the screw cap (Order No.: 3RK1 901-1KA00) from the
addressing socket.
3 Connect the addressing and diagnostic unit to the addressing socket.
4 Set the required address.
5 After carrying out addressing, screw the screw cap back into the socket
in order to obtain degree of protection IP 67.
Addressing socket
Connecting lead
Screw cap
S
AUX PWR
STATE
IN.2
ADDR.
DEVICE
X1
X3
Addressing socket